User`s manual

Piranha HN RoHS User Manual
03-032-20135-01 Teledyne DALSA
32
Setting Frame Rate
Purpose:
Sets the camera‘s frame rate in Hz. Camera must be op eratin g in exp osure m ode 7.
Syntax:
ssf i
Syntax Elements:
i
Set the frame rate to a value from:
TDI : 1-34246
Area : 1-130
Value rounded up/ down as required. The maximum line/ frame rate is affected by
horizontal and vertical binning factors, throughput setting, Camera Link mode, and
number of CCD integration stages.
Notes:
If you enter a frame rate frequency outside of the range displayed on the help screen, an
error message is returned and the frame rate remains unchanged.
With internal exposure mode, sem 7, the camera automatically clips the frame rate after
binning or the camera link mode if the sync frequency is greater than the allowable
maximum.
The camera does not automatically change the frame rate after you change the stage
selection value. To retu rn the camera‘s frame rate, use the command gcp or get ssf.
Related Commands:
sem
Example:
ssf 10000