User`s manual

Piranha HN RoHS User Manual
Teledyne DALSA 03-032-20135-00
7
Mechanical Interface
Model HN-80-08k40
Camera Size
80 (l) x 150 (h) x 65 (w)
Mass
< 800 g
Connectors 6 pin male Hirose, power
MDR26 female, data
Electrical Interface
Model HN-80-08k40
Input Voltage
+ 12 to + 15 ± 5 % Volts DC
Power Dissipation
2
18.5 W
Operating Temperature
3 0 to 50 °C
Bit Width
8 or 12 bit user selectable bits
Output Data Configuration
Base, Medium or Full Camera Link
Operating Ranges
Model HN-80-08k40
Maximum Line Rate
34 kHz
Throughput
Selectable 80, 160, 320 or 640 Mpix / sec
Gain
0 to +20 dB
Calibration Time
4.3 seconds
Performance Gain 0 dB Gain +10 dB Gain +20 dB
Min Typ Max Min Typ Max Min Typ Max
Dynamic Range TBD TBD TBD TBD TB
D
TBD
Random Noise
DN rms
TBD TBD TBD TBD TBD TBD
SEE nJ / cm
2
TBD TBD TBD
NEE pJ / cm
2
TBD
TBD
TBD
TBD
TBD
TBD
Analog Broadband Responsivity
(DN / nJ / cm
2
)
See
Graph
FPN DN p-p TBD TBD
PRNU DN p-p TBD TBD
Saturation Output Amplitude
DN
255 typ
DC Offset
DN
3 min 5 typ 6 max
Test conditions for all models, unless otherwise noted:
• TDI mode of operation. These specifications are not guaranteed for area mode of operation.
• Line Rate: 10 kHz.
• Nominal Gain setting.
• Light Source: Broadband Quartz Halogen, 3250 k, with 700 nm IR cut-off filter installed.
• All Max specifications are valid over a 0-50 °C temperature range.