User`s manual

Piranha HN RoHS User Manual
Teledyne DALSA 03-032-20135-00
21
gla get line average xx 1-8192:1-8192
gsf get signal frequency m 1/3/
h help
? single command help s
rc reset camera
rfs restore factory settings
rus restore user settings
sab set add background i 0-4096
sbh set binning horizontal m 1/2/4
sbv set binning vertical m 1/2/4
scd set ccd direction i 0-2
sdh set digital horizontal binningm 1/2/4
sem set exposure mode m 3/7/
sg set gain f -20-+20
smm set mirroring mode i 0-1
sot set output throughput m 320/640
spr set prnu range xxi 1-8192:1-8192:0-61438
ssb set subtract background i 0-4096
ssf set sync frequency f 1-130
ssg set system gain i 0-61438
ssn set set number i 0-4
stg set stage selection m 16/64/128/192/240/256/
svm set video mode i 0-4
tdi set tdi/area mode i 0-1
ugr update gain reference
vt verify temperature
vv verify voltage
wus write user settings
OK>
First Power Up Camera Settings
When the camera is powered up for the first time, it operates using the following factory settings:
• TDI mode
• Left to right pixel readout
• Forward CCD shift direction
• 256 integration stages
• No binning
• Camera Link Mode 21 (8 bit, 8 taps)
• Exposure mode 7
• 7.5kHz line rate
• 640 throughput
• Factory calibrated analog gain and offset
Factory calibrated FPN and PRNU coefficients using the following process:
ssf
7500
(line rate of 7.5 kHz)
ccg
12800 (gain calibrated to an average pixel value of 3200)