User`s manual

Linea 2K, 4K, 8K and 16K Camera User's Manual PRELIMINARY 71
Teledyne DALSA 03-032-20206-01
Full Name
Calibrate Flatfield
Mnemonic
CPA
Argument(s)
Algorithm
0. Basic
1. Low-pass Filter
# of lines to average
 2048
 4096
Target
0 to 4095 DN in 12 bit mode
0 to 255 DN in 8 bit mode
Description
Calibrate user PRNU flat field coefficients
Notes
 Perform flat field calibration using the average of <# lines>.
 With filter algorithm this average line is then smoothed and outlier pixels are
interpolated. Use this feature if your white reference is not featureless.
 Adjust pixel gain such that output will be <target>.
 The target is first divided by horizontal binning factor and gain and then the
offset is subtracted. Therefore the output will go to the target.
 Because the PRNU can be less than 1, the target may be below the current
maximum value.
 Coefficients are saved and loaded with user set (e.g. USS / USL)
Full Name
Disable Esc Key
Mnemonic
DEK
Argument(s)
Mode
0. Esc key is enabled
1. Esc key is disabled
Description
Allow the use of the Esc key to be disabled so that upon boot-up the camera will directly enter
the ASCII command mode. With the Esc key disabled the GENCP cannot be accessed.
Notes
To access the GenCP, you have to first issue the DEK 0 command in order to enable the
ESC key. Then reboot the camera.
Full Name
Flatfield Mode
Mnemonic
FFM
Argument(s)
Mode
0. Disable use of user FPN and PRNU flat field
correction coefficients.
1. Enable use of user FPN and PRNU flat field
correction coefficients.
2. Reset user FPN coefficients to zero and user
PRNU coefficients to one.
Description
Set flat field mode
Notes