User`s manual

34  Operational Reference Genie HM-HC Series-GigE Vision Camera
Read Only Parameters
Parameter Description
Device Vendor Name For the Genie HM series, this is always DALSA.
Device Model Name Displays the device model name
Device Version Displays the device version which includes the firmware release and build.
Firmware Version Displays the currently loaded firmware version manufacturer's code.
Device ID Displays the factory set camera serial number.
MAC Address Displays the unique MAC (Media Access Control) address of the Genie camera.
User Set Parameters
Parameter Description
Device User ID Specifies a user written ID, of up to 15 characters, for the Genie camera.
By default, this field is set to the serial number of the camera.
Power-up Configuration
Click Setting to open the Power-up configuration dialog box which allows you to specify
camera power-up configuration. For more information, see "Power-up Configuration" on page
34.
Power-up Configuration (Saved User Settings)
The Power-up configuration dialog allows you to specify the camera configuration to load when powering-up the
camera. The Genie camera flash memory contains two possible configuration settings; the Factory Default (neutral
parameters and in free run mode), and a user-defined Camera Configuration 1. The Camera Power-up
configuration drop-down list box allows you to select either the Factory Default or a user specified camera
configuration file. To save the current CamExpert settings to the camera user-defined (Camera Configuration)
setting, click Save. To view in CamExpert a camera configuration file currently saved in the camera, select the
configuration file in the Load configuration from Camera drop-down list, and click Load. See the parameter list
below.