User`s manual

Genie HM-HC Series-GigE Vision Camera Installing the Genie Camera  23
Genie CD Package Installation
The Genie Framework software package and Sapera runtime provides all components required to control the Genie
with the supplied CamExpert tool. Genie Framework software components include the Network Imaging driver
(refer to the DALSA Network Imaging package manual), the Sapera GigE server, and CamExpert (if Sapera LT
library is not installed).
Note: If Sapera application development is required, install Sapera (6.20 or later) as described in the previous
section.
Procedure
 When upgrading the Genie Framework from a previous version, there is no need to uninstall the older
version. The new installation will correctly update all framework files.
 Insert the DALSA Genie CD-ROM. If AUTORUN is enabled on your computer, the Genie installation menu is
presented.
 If AUTORUN is not enabled, use Windows Explorer and browse to the root directory of the CD-ROM.
Execute launch.exe to start the installation menu and install the Genie software components.
 Click to install the Genie Framework Software which includes the Network Imaging driver, and the Sapera
GigE server.
 The procedure will prompt for acceptance of the installation folder for the Genie files.
 If desired, click to install Sapera LT run-time which includes CamExpert. Follow the on screen prompts and
reboot when the installation is complete.
GigE Server Verification
After a successful Genie Framework package installation, the GigE Server icon is visible in the desktop taskbar tray
area. After connecting a camera (see following section), allow a few seconds for the GigE Server status to update.
The Genie camera must be on the same subnet as the NIC to be recognized by the GigE Server.
Device Available Device IP Error Device Not Available
GigE Server
Tray Icon:
The normal GigE server tray
icon when the Genie device is
found. It will take a few
seconds for the GigE Server to
refresh its state after the Genie
has obtained an IP address.
The GigE server tray icon
shows a warning when a device
is connected but there is some
type of IP error.
A red X will remain over the
GigE server tray icon when the
Genie device is not found. This
indicates a major network
issue. Or in the simplest case,
the Genie is not connected.
If you place your mouse cursor on this icon, the GigE Server will display the number of GigE Vision devices found
by your PC. Right click the icon and select status to view information about those devices. See "Running the
Net
work Configuration Tool" on page 27 and "Troubleshooting" on page 125for m
ore information.