User`s manual

Genie HM-HC Series-GigE Vision Camera Technical Specifications  107
Additional Notes on Genie Mechanical
Genie supports a screw lock Ethernet cable (see "Ruggedized RJ45 Ethernet Cables" on page 119).
For information on Genie lens requirements see "Optical Considerations" on page 112.
Lens flange focal distance = 17.52 mm.
Lens flange focal distance = 12.52 mm for CS-mount.
The cam
era top also has four mounting holes in identical locations.
Overall length tolerance is ± 0.35mm.
Overall height or width tolerance is ± 0.15mm.
Sensor Alignment Specification
The following figure specifies sensor alignment for Genie where all specifications define the absolute maximum
tolerance allowed for production cameras. Dimensions "x, y, z", are in microns and referenced to the Genie
mechanical body or the optical focal plane (for the z-axis dimension). Theta specifies the sensor rotation relative to
the sensor's center and Genie mechanical.
+/- 150
+/- 150
Sensor Alignment Specifications
dimensions in microns (not shown to scale)
x = +/- 150 microns
y = +/- 150 microns
z = +/- 300 microns (not shown)
theta = +/- 0.3 degrees
±Ø.3°