User`s manual
Table Of Contents
- Introduction to the Falcon XDR and HG Cameras
- Camera Hardware Interface
- Serial Interface: How to Control the Camera
- Serial Protocol Defaults
- Command Format
- 3.1 Setting Baud Rate
- 3.2 Camera Serial Command Help Screen
- 3.3 Retrieving Information About the Camera
- 3.4 First Power Up Camera Settings
- 3.5 Saving and Restoring Settings
- 3.6 Camera Output Format
- 3.7 Setting Exposure Mode, Frame Rate and Exposure Time
- 3.8 Setting a Vertical Window of Interest
- 3.9 Flat Field Correction
- 3.10 Gain Adjustments
- 3.11 Generating a Test Pattern
- Optical and Mechanical Considerations
- Troubleshooting
- Appendix A: Camera Link™ Reference, Timing, and Configuration Table
- Appendix B: Error Handling and Command List
- Appendix C: EMC Declaration
- Technical Support
- Index
DALSA Falcon XDR and HG Series Camera User's Manual
88 Appendix B: Error Handling and Command List
27 Error 27: Reserved factory coefficient set, change coefficient set number>
28 Warning 28: Coefficient may be inaccurate A/D clipping has occurred>
29 Warning 29: Greater than 1% of coefficients have been clipped>
30 Error 30 : ECC failure>
31 Error 31 : ECC failure and set corrupt>
32 Error 32 : ECC failure and set not available>
33 Error 33 : Set not available>
34 Error 34: Incorrect number of parameters>
35 Error 35: Incompatible camera model>
36 Error 36: Incompatible firmware>
37 Error 37: File transfer cancelled>
38 Error 38: Invalid CBF file>
39 Warning 39: Clipped to min/max>
40 Warning 40: Changed to nearest valid value>