User`s manual
Table Of Contents
- Introduction to the Falcon XDR and HG Cameras
- Camera Hardware Interface
- Serial Interface: How to Control the Camera
- Serial Protocol Defaults
- Command Format
- 3.1 Setting Baud Rate
- 3.2 Camera Serial Command Help Screen
- 3.3 Retrieving Information About the Camera
- 3.4 First Power Up Camera Settings
- 3.5 Saving and Restoring Settings
- 3.6 Camera Output Format
- 3.7 Setting Exposure Mode, Frame Rate and Exposure Time
- 3.8 Setting a Vertical Window of Interest
- 3.9 Flat Field Correction
- 3.10 Gain Adjustments
- 3.11 Generating a Test Pattern
- Optical and Mechanical Considerations
- Troubleshooting
- Appendix A: Camera Link™ Reference, Timing, and Configuration Table
- Appendix B: Error Handling and Command List
- Appendix C: EMC Declaration
- Technical Support
- Index
Falcon XDR and HG Series Camera User's Manual DALSA
Appendix B: Error Handling and Command List 87
B.2 Error Messages
As a quick reference, the following table lists all of the error and warning messages the camera user
could experience.
Error \ Warning Code Camera Response
1 Error 1: Invalid command>
2 Error 2: Command parameters incorrect or out of range>
3 Error 3: Internal camera error>
4 Error 4: Camera memory check failure>
5 Error 5: Command unavailable in this mode>
6 Error 6: Unable to configure camera>
7 Error 7: The camera's temperature is outside the specified operating
range>
8 Error 8: Failure while attempting to restore the camera settings>
9 Not used
10 Error 10: General timeout error>
11 Not used
12 Not used
13 Error 13: SPI device not responding>
14 Error 14: Unable to read/write to the internal config device>
15 Error 15: Invalid baudrate>
16 Error 16: Failure downloading file
17 Warning 17: Related parameters adjusted>
18 Error 18: FFC coefficients memory failure>
19 Not used
20 Not used
21 Not used
22 Not Used
23 Error 23: Settings not saved>
24 Not Used
25 Warning 25: Analog Offset automatically adjusted>
26 Error 26: One or more voltages outside specified operating range>