User`s manual
Table Of Contents
- Introduction to the Falcon XDR and HG Cameras
- Camera Hardware Interface
- Serial Interface: How to Control the Camera
- Serial Protocol Defaults
- Command Format
- 3.1 Setting Baud Rate
- 3.2 Camera Serial Command Help Screen
- 3.3 Retrieving Information About the Camera
- 3.4 First Power Up Camera Settings
- 3.5 Saving and Restoring Settings
- 3.6 Camera Output Format
- 3.7 Setting Exposure Mode, Frame Rate and Exposure Time
- 3.8 Setting a Vertical Window of Interest
- 3.9 Flat Field Correction
- 3.10 Gain Adjustments
- 3.11 Generating a Test Pattern
- Optical and Mechanical Considerations
- Troubleshooting
- Appendix A: Camera Link™ Reference, Timing, and Configuration Table
- Appendix B: Error Handling and Command List
- Appendix C: EMC Declaration
- Technical Support
- Index
DALSA Falcon XDR and HG Series Camera User's Manual
86 Appendix B: Error Handling and Command List
Syntax Command Params Description
wfc
write FPN
coefficients
Saves the FPN coefficients
wpc
write PRNU
coefficients
Saves the PRNU coefficients
wse
window start end
i i x1 y1
x2 y2
Sets the window start and stop pixels where:
i is the window sequence id. It is always 0 in this camera.
i is the number of windows to set. It is always 1 in this
camera.
x1 is window start corner value. Ranges from 0-1399.
y1 is window start pixel number. Ranges from 0-1023.
x2 is window end corner value. Ranges from 15-1399.
y2 is window end pixel number . Ranges from 15-1023.
wus
write user
settings
Write all of the user settings to non-volatile memory.