User`s manual
Table Of Contents
- Introduction to the Falcon XDR and HG Cameras
- Camera Hardware Interface
- Serial Interface: How to Control the Camera
- Serial Protocol Defaults
- Command Format
- 3.1 Setting Baud Rate
- 3.2 Camera Serial Command Help Screen
- 3.3 Retrieving Information About the Camera
- 3.4 First Power Up Camera Settings
- 3.5 Saving and Restoring Settings
- 3.6 Camera Output Format
- 3.7 Setting Exposure Mode, Frame Rate and Exposure Time
- 3.8 Setting a Vertical Window of Interest
- 3.9 Flat Field Correction
- 3.10 Gain Adjustments
- 3.11 Generating a Test Pattern
- Optical and Mechanical Considerations
- Troubleshooting
- Appendix A: Camera Link™ Reference, Timing, and Configuration Table
- Appendix B: Error Handling and Command List
- Appendix C: EMC Declaration
- Technical Support
- Index
DALSA Falcon XDR and HG Series Camera User's Manual
84 Appendix B: Error Handling and Command List
Syntax Command Params Description
sdc
Set digital color
gain
t i
Allows user to manually set digital color gains for
individual colors. The allowable range is 1 to 4.
1 = Red,
2 = Green (Red),
3 = Green (Blue), and
4 = Blue.
Minimum = 1024
Maximum = 8191
sdo
set digital offset
t i
Set the digital offset as a DN, which is added to the digital
video signal.
t: tap selector: this is always 0 (all taps)
i: the digital offset (0-1023 DN)
sem
Set exposure
mode
m
Set the exposure mode. Available values are:
2: Internal SYNC, programmable frame rate and exposure
time using commands ssf and set.
4: Smart EXSYNC.
6: External frame rate, fixed exposure time
9: Sequential Smart EXSYNC.
10: Sequential external frame rate, fixed exposure time
set
set exposure
time
f
Sets the exposure time to a floating point number in µs.
Allowable range is 250-4194303 µs.
sfc
Set FPN
Coefficient
x y i
x = 1-1400
y = 1-1024
i = 0-255
slc
set LUT
coefficient
i i
Specifies the LUT input pixel value and output value. All
other pixel values are then calculated linearly.
i :Input pixel value. Possible values are 0-1023.
i : Output pixel value. Possible values are 0-1023.
sle
set LUT enable
i
Enables or disables the camera LUT.
0: LUT disabled
1: LUT enabled