User`s manual
Table Of Contents
- Introduction to the Falcon XDR and HG Cameras
- Camera Hardware Interface
- Serial Interface: How to Control the Camera
- Serial Protocol Defaults
- Command Format
- 3.1 Setting Baud Rate
- 3.2 Camera Serial Command Help Screen
- 3.3 Retrieving Information About the Camera
- 3.4 First Power Up Camera Settings
- 3.5 Saving and Restoring Settings
- 3.6 Camera Output Format
- 3.7 Setting Exposure Mode, Frame Rate and Exposure Time
- 3.8 Setting a Vertical Window of Interest
- 3.9 Flat Field Correction
- 3.10 Gain Adjustments
- 3.11 Generating a Test Pattern
- Optical and Mechanical Considerations
- Troubleshooting
- Appendix A: Camera Link™ Reference, Timing, and Configuration Table
- Appendix B: Error Handling and Command List
- Appendix C: EMC Declaration
- Technical Support
- Index
Falcon XDR and HG Series Camera User's Manual DALSA
Appendix B: Error Handling and Command List 83
Syntax Command Params Description
lpc
Load pixel
coefficients
ocf
Set offset
correction factor
f
Allows user to manually set the temperature color offset
correction factor i.e. slope.
Minimum = 1.00
Maximum = 4.00
rc
reset camera
Reset the entire camera (reboot).
rct
Read calibration
temperature
Display the temperature at which the camera was
calibrated
rfs
restore factory
settings
Restore the camera’s factory settings.
rpc
reset pixel
coefficients
Resets the pixel coefficients to factory settings.
rus
restore user
settings
Restore the camera’s last saved user settings.
sbh
set horizontal
binning
i
Sets the horizontal binning.
1: no binning
2: each pixel value is formed from 2 adjacent pixels,
effectively reducing the frame width in half.
sbr
set baud rate
m
Set the speed of the serial communication port. Baud
rates: 9600, 19200, 57600, and 115200. Default baud:
9600.
sbv
set vertical
binning rate
i
Sets the vertical binning.
1: no binning
2: each pixel value is formed from 2 adjacent pixels on
consecutive lines, effectively reducing the frame height in
half.