User`s manual
Table Of Contents
- Introduction to the Falcon XDR and HG Cameras
- Camera Hardware Interface
- Serial Interface: How to Control the Camera
- Serial Protocol Defaults
- Command Format
- 3.1 Setting Baud Rate
- 3.2 Camera Serial Command Help Screen
- 3.3 Retrieving Information About the Camera
- 3.4 First Power Up Camera Settings
- 3.5 Saving and Restoring Settings
- 3.6 Camera Output Format
- 3.7 Setting Exposure Mode, Frame Rate and Exposure Time
- 3.8 Setting a Vertical Window of Interest
- 3.9 Flat Field Correction
- 3.10 Gain Adjustments
- 3.11 Generating a Test Pattern
- Optical and Mechanical Considerations
- Troubleshooting
- Appendix A: Camera Link™ Reference, Timing, and Configuration Table
- Appendix B: Error Handling and Command List
- Appendix C: EMC Declaration
- Technical Support
- Index
DALSA Falcon XDR and HG Series Camera User's Manual
82 Appendix B: Error Handling and Command List
Syntax Command Params Description
csn
coefficient set
number
i
Selects the coefficient set to use, either:
0 = Factory calibrated set of FPN and PRNU coefficients.
These coefficients cannot be erased or modified.
1 = User calibrated set of FPN and PRNU coefficients.
These coefficients can be deleted or modified.
css
calibration
sample size
m
Sets the number of lines to sample when performing FPN
and PRNU calibration where m is 32(factory setting), 64,
128 , 256, 512, or 1024
ecg
enable color
gain
i
Enables or disables digital color gains
0 = Disabled
1 = Enabled
eoc
enable offset
correction
i
Enables or disables temperature color offset correct
0 = Disabled
1 = Enabled
gcp
get camera
parameters
Read all of the camera parameters.
gcs
get camera
serial
Read the camera serial number.
gcv
get camera
version
Read the firmware version and FPGA version.
get
get command
parameter
s
Display value of camera command s
gfc
Get FPN
Coefficient
x y x = 1-1400
y = 1-1024
gh
get help
Display the get help screen
gsf
get sync
frequency
i
Displays the frames per second. (i = 1)
h
help
Display the online help