User`s manual
Table Of Contents
- Introduction to the Falcon XDR and HG Cameras
- Camera Hardware Interface
- Serial Interface: How to Control the Camera
- Serial Protocol Defaults
- Command Format
- 3.1 Setting Baud Rate
- 3.2 Camera Serial Command Help Screen
- 3.3 Retrieving Information About the Camera
- 3.4 First Power Up Camera Settings
- 3.5 Saving and Restoring Settings
- 3.6 Camera Output Format
- 3.7 Setting Exposure Mode, Frame Rate and Exposure Time
- 3.8 Setting a Vertical Window of Interest
- 3.9 Flat Field Correction
- 3.10 Gain Adjustments
- 3.11 Generating a Test Pattern
- Optical and Mechanical Considerations
- Troubleshooting
- Appendix A: Camera Link™ Reference, Timing, and Configuration Table
- Appendix B: Error Handling and Command List
- Appendix C: EMC Declaration
- Technical Support
- Index
Falcon XDR and HG Series Camera User's Manual DALSA
Appendix A: Camera Link™ Reference, Timing, and Configuration Table 79
A.7 Bit Assignments According to Configuration
The following table describes the bit assignments for both 8-bit and 10-bit 2 tap base configuration (clm 2
and clm 3). The two taps are interleaved and provide consecutive pixels simultaneously (for example,
with the 8-bit configuration, port A starts with pixel 0 and port B pixel 1, and so on).
Port/bit 8-bit 10-bit
Port A0 A0 A0
Port A1 A1 A1
Port A2 A2 A2
Port A3 A3 A3
Port A4 A4 A4
Port A5 A5 A5
Port A6 A6 A6
Port A7 A7 A7
Port B0 B0 A8
Port B1 B1 A9
Port B2 B2 Not used
Port B3 B3 Not used
Port B4 B4 B8
Port B5 B5 B9
Port B6 B6 Not used
Port B7 B7 Not used
Port C0 Not used B0
Port C1 Not used B1
Port C2 Not used B2
Port C3 Not used B3
Port C4 Not used B4
Port C5 Not used B5
Port C6 Not used B6
Port C7 Not used B7