User`s manual
Table Of Contents
- Introduction to the Falcon XDR and HG Cameras
- Camera Hardware Interface
- Serial Interface: How to Control the Camera
- Serial Protocol Defaults
- Command Format
- 3.1 Setting Baud Rate
- 3.2 Camera Serial Command Help Screen
- 3.3 Retrieving Information About the Camera
- 3.4 First Power Up Camera Settings
- 3.5 Saving and Restoring Settings
- 3.6 Camera Output Format
- 3.7 Setting Exposure Mode, Frame Rate and Exposure Time
- 3.8 Setting a Vertical Window of Interest
- 3.9 Flat Field Correction
- 3.10 Gain Adjustments
- 3.11 Generating a Test Pattern
- Optical and Mechanical Considerations
- Troubleshooting
- Appendix A: Camera Link™ Reference, Timing, and Configuration Table
- Appendix B: Error Handling and Command List
- Appendix C: EMC Declaration
- Technical Support
- Index
Falcon XDR and HG Series Camera User's Manual DALSA
Serial Interface: How to Control the Camera 47
Serial Command: wse
To set a window of interest:
• Set the window coordinates, using the window start end command:
wse 0 1 x y x y.
The maximum frame rate increases as you decrease the sequence size.
Purpose: Sets a window of interest.
Syntax:
• wse q i x1 y1 x2 y2
Syntax Elements:
• q
Window sequence id to use. In this camera, the
sequence id is always 0.
• i
Window to set. You can only set one window, so
this is always
1.
• x1
Window horizontal start corner pixel number, in a
range from 0 – 1399 and must belong to the
following set: 1, 5, 9 , ... 1399.
• y1
Window vertical start corner pixel number, in a
range from
0-1023.
• x2
Window horizontal end corner pixel number, in a
range from
15-1399 mustbelongtothefollowingset:
15, 19 , ... 1399..Theminimumwindowwidthis16
pixels.
• y2
Window vertical end pixel number in range from 1-
1023.
Example:
• wse 0 1 1 13 1399 1023