User`s manual
Table Of Contents
- Introduction to the Falcon XDR and HG Cameras
- Camera Hardware Interface
- Serial Interface: How to Control the Camera
- Serial Protocol Defaults
- Command Format
- 3.1 Setting Baud Rate
- 3.2 Camera Serial Command Help Screen
- 3.3 Retrieving Information About the Camera
- 3.4 First Power Up Camera Settings
- 3.5 Saving and Restoring Settings
- 3.6 Camera Output Format
- 3.7 Setting Exposure Mode, Frame Rate and Exposure Time
- 3.8 Setting a Vertical Window of Interest
- 3.9 Flat Field Correction
- 3.10 Gain Adjustments
- 3.11 Generating a Test Pattern
- Optical and Mechanical Considerations
- Troubleshooting
- Appendix A: Camera Link™ Reference, Timing, and Configuration Table
- Appendix B: Error Handling and Command List
- Appendix C: EMC Declaration
- Technical Support
- Index
DALSA Falcon XDR and HG Series Camera User's Manual
42 Serial Interface: How to Control the Camera
Mode 10: External Frame Rate, Fixed Exposure Time
In this mode, the frame rate is triggered externally using the EXSYNC falling edge. There is a 100μs
delay between the trigger and the start of the exposure. The minimum exposure time is 10μs. The
minimum delay between the readout and the next EXSYNC is 1μs. Note, the exposure and readout time
cannot overlap.