User`s manual
Table Of Contents
- Introduction to the Falcon XDR and HG Cameras
- Camera Hardware Interface
- Serial Interface: How to Control the Camera
- Serial Protocol Defaults
- Command Format
- 3.1 Setting Baud Rate
- 3.2 Camera Serial Command Help Screen
- 3.3 Retrieving Information About the Camera
- 3.4 First Power Up Camera Settings
- 3.5 Saving and Restoring Settings
- 3.6 Camera Output Format
- 3.7 Setting Exposure Mode, Frame Rate and Exposure Time
- 3.8 Setting a Vertical Window of Interest
- 3.9 Flat Field Correction
- 3.10 Gain Adjustments
- 3.11 Generating a Test Pattern
- Optical and Mechanical Considerations
- Troubleshooting
- Appendix A: Camera Link™ Reference, Timing, and Configuration Table
- Appendix B: Error Handling and Command List
- Appendix C: EMC Declaration
- Technical Support
- Index
Falcon XDR and HG Series Camera User's Manual DALSA
Serial Interface: How to Control the Camera 33
• Flat field coefficients enabled (Factory FFC coefficients calibrated in exposure mode 2, 10 bit, 50
fps)
• Exposure mode 2
• 100 fps
• 9000 µs exposure time
• Camera Link mode 2 (Base configuration, 2 taps, 8 bits)
• 80Mpixels/s per tap
• Full resolution
3.5 Saving and Restoring Settings
User
Setting
Factory
Setting
Current
Session
rfs
rus
wus
Serial Commands for Saving and Restoring Settings
3.5.1 Factory Settings
You can restore the original factory settings at any time using the serial command rfs.
Note: This command does not restore flat field coefficients. Refer to
lpc command.