User`s manual
Table Of Contents
- Introduction to the Falcon XDR and HG Cameras
- Camera Hardware Interface
- Serial Interface: How to Control the Camera
- Serial Protocol Defaults
- Command Format
- 3.1 Setting Baud Rate
- 3.2 Camera Serial Command Help Screen
- 3.3 Retrieving Information About the Camera
- 3.4 First Power Up Camera Settings
- 3.5 Saving and Restoring Settings
- 3.6 Camera Output Format
- 3.7 Setting Exposure Mode, Frame Rate and Exposure Time
- 3.8 Setting a Vertical Window of Interest
- 3.9 Flat Field Correction
- 3.10 Gain Adjustments
- 3.11 Generating a Test Pattern
- Optical and Mechanical Considerations
- Troubleshooting
- Appendix A: Camera Link™ Reference, Timing, and Configuration Table
- Appendix B: Error Handling and Command List
- Appendix C: EMC Declaration
- Technical Support
- Index
DALSA Falcon XDR and HG Series Camera User's Manual
26 Camera Hardware Interface
2.3 Image Sensor and Pixel Readout
The camera uses DALSA’s new DCR1410M, 1.4 mega pixel, 1400 x 1024 CMOS sensor.
Row 2
Column 1
Tap 1
Row 1
Column 1
Tap 1
Row 2
Column 2
Tap 1
Row 1
Column 2
Tap 1
Row 2
Column 1399
Tap 1
Row 1
Column 1399
Tap 1
Row 2
Column 1400
Tap 1
Row 1
Column 1400
Tap 1
Row 1024
Column 1
Tap 1
Row 1023
Column 1
Tap 1
Row 1024
Column 2
Tap 1
Row 1023
Column 2
Tap 1
Row 1024
Column 1399
Tap 1
Row 1023
Column 1399
Tap 1
Row 1024
Column 1400
Tap 1
Row 1023
Column 1400
Tap 1
Pixel 1
Pixel read out direction is left to right then bottom to top
Sensor Block Diagram
Note: As viewed from the front of the camera without lens. The bottom of the camera has a
¼-20 tripod mount.