User`s manual

PANTERA 22M User’s Manual 45
Teledyne DALSA 03-032-20049-02
Appendix B
Commands and Error Handling
This table provides a brief overview of all of the available user commands. For a detailed
explanation of these commands, refer to Chapter 3.
Table: All Available CommandsTable 3Table 4
Command
Syntax
Parameters
Description
FPGA
configuration
store
fcs
Place the camera into FPGA code download
state. Use HyperTerminal application to
download the binary image of the FPGA
configuration the file, the camera needs to be
reset or power cycled.
Before starting the download process with
this com m end , the camera’s serial d ata rate
should be increased by using the sbr. A
baud rate of 115200 is recommended.
get analog gain
gag
Read the camera analog gain
get analog
offset
gao
Read the camera analog offset
get camera
model
gcm
Read the camera model number
get camera
parameters
gcp
Read all of the camera parameters.
get camera
serial
gcs
Read the camera serial number
get camera
version
gcv
Read the firmware version and FPGA version
get sensor
serial
gss
Read the sensor serial number
help
h
Display the online help
camera link
mode
clm
i
Sets the data mode to use. Available values
are:
0: 12 bit mode
1: 10 bit mode
2: 8 bit mode
reset camera
rc
Reset the entire camera (reboot)
restore factory
settings
rfs
Restore the cam era’s factory settings.
restore user
settings
rus
Restore the camera's last saved user settings.
Parameters:
i = integer
f = float
t = tap