Specifications
The VRS can be adjusted from 1.25 to 6.2 volts. The maximum output current is 1/2 ampere.
VRS is suitable for many applications:
• stationary lighting of building interiors, building ceiling and outside lights, street
lights, marquees.
• lighting passenger cars, cabooses. This unit is also LocoMatic™ compatible.
• Since it supplies 6 volts, it can be used for various smoke units and other items.
• use with various lamps or LED's with appropriate limiting resistors.
• can be used to power LED's from RL-LED boards (shown on previous page) when
removed from the main power strip.
The VRS, item #378, is supplied with plug connectors for the input and output connections with approximately 6" of wire. The VRS has no
electrical items on the bottom side of it's board. This makes mounting an easy task on metallic or non-metallic surfaces. The VRS can be
secured in place with glue, double sided tape (item 388), or Velcro. Requires input voltage greater than the output voltage up to 25 volts
AC, or 35 v DC maximum. Input voltage may be from a stationary supply or track power. Track power can be DCC, DC, AC, TMCC, or
DCS!
52
em 513 ........ DPDT miniature toggle switch. 6amp, 125v.
Mounting hole: 1/4".
Item 523 ...... DPDT miniature toggle switch - center off. 6amp,
125v. Mounting hole: 1/4" hole mounting.
Auto Whistle/Horn Sound System Accessories
(G operators)
Item 988 ..... Magnet for reed switch operation.
5/8" diamater x 3/8"
high. Perfect for "G" gauge track and other uses.
Item 991 ...... two small magnets, 0.045" x 0.1" x 0.2"
Item 992 ...... Prewired USA Trains with 2 pin female power plug.
Yields "plug-n-play" operation when operating on
DC track power.
Item 993 ...... Prewired AristoCraft engine with a 3 plug mother
board to Dallee DCv3 type sound systems. Yields
"plug-n-play" operation when operating on DC track
power.
Item 996 ...... complete items for using 8.4v rechargeable battery
(included) with Dallee DCv3 type sound systems
(standard and auto types).
Item 997 ...... prewired 996. Includes 8.4v rechargeable battery.
Item 690, wall plug in power transformer, is rated at 16vAC, 2.5
ampere's (40VA) output, 120vAC input. It can be used to power
several items such as the: 9VPS (item 359), 12VPS (item 369),
RL-ADJ (item 379), VRS (item 378), and all LED lighting strips.
Use a bridge rectifier (item 371) to make a DC supply capable
of powering several polarity reverse switch machines. This
power transformer is internally fused, so you have to be careful
not to overload or short the output terminals.
1.25"w x 1"l x 0.35"h
Adjustable Regulated Power Supply module
Item # 378
9VPS - Regulated 9 volt Power Supply
The 9VPS is a "regulated" 9 volt DC power supply. It is intended to power
devices that require 9 volts DC. It can be used to replace a 9v battery. Input to
the 9VPS should be 12-18 volts AC. This input power can come from the
accessory terminals of most power packs or from a separate transformer. A DC
input may also be used but should be 12-20 volts DC. The 9VPS is "regulated"
so it can supply a consistent 9 volts DC to numerous devices regardless of
changes in load current. The 9VPS is capable of delivering 1/2 ampere.
Adequate input power is required for proper operation.
Item # 359
Physical size:
3.6" l x 2.6"w x 2.1"h
(subject to change w/o notice)
Item 998 ...... Prewired AristoCraft engine with a 2 plug mother
board to Dallee DCv3 type sound systems. Yields
"plug-n-play" operation when operating on DC track
power.
Item 999 ...... AristoCraft connector assembly. Includes one two
and one three pin connector wire harness.
POWER TRANSFORMER
Item #690