Specifications

39
TRAcK-DT family, basic wiring instructions
TRAK-DTT
TRAK-DT
TRAK-DTT2
12VPS
12 VOLT / 0.5 Amp
REGULATED POWER SUPPLY
install wires by stripping insulation
back 3/16", place wire in hole, run
screw down to clamp in position.
INPUT POWER
14 to 20 Volts AC
( 16 vAC typical)
0.75 Amps
OUTPUT POWER
Regulated 12 volts DC. Make sure
that the "+" goes to the "+" and the
"-" to the "-". Damage can occur to
the devices if improperly connected!
#6 mounting
screw hole
#6 mounting
screw hole
+
-
Heatsink - gets warm during normal
operation. DO NOT allow the
heatsink to come in contact with
any other electrical wire or metal. It
does connect to the "-" of the DC
output power. Allow for adequate
ventillation.
If the heatsink becomes super hot
you probably have a short or
overload connected to the output
power. Turn the power off and
recheck your connections.
install stranded wires by stripping insulation back
3/16", place wire in hole, run screw down to clamp in position. Make sure wires do not short
to adjacent terminals.
12VPS #369
fixed
15-20
VAC
power
G
A
P
pwr(+)
Mode selector:
Jumper ON = mode 1, DTA
Jumper Off = mode 2, DTT
GAP - cut rail leaving an air gap or use plastic / fibre insulators.
expansion
connector
Sensor Input: pass
wire THROUGH
HOLE (do not strip
insulation)
pwr(–)
G
A
P
time
adjust
N/C
C
N/O
N/C
C
N/O
sect 'A'
sect 'B'
Mounting standoff,
use #6 wood
screw. 3/unit
+
12VDC
–
a c t i v a t i o n s e c t i o n
12VPS #369
stop section
G
A
P
GAP
fixed
15-20
VAC
power
time
adjust
Sensor Input:
pass wire
THROUGH
HOLE (do not
strip insulation)
install stranded wires by stripping insulation back
3/16", place wire in hole, run screw down to clamp in position. Make sure wires do not short
to adjacent terminals.
expansion
connector
sect 'A'
sect 'B'
pwr(–)
N/C
C
N/O
pwr(+)
N/C
C
N/O
install stranded wires by stripping insulation back
3/16", place wire in hole, run screw down to clamp in position. Make sure wires do not short
to adjacent terminals.
12VPS #369
fixed
15-20
VAC
power
GAP
pwr(+)
GAP - cut rail leaving an air gap or use plastic / fibre insulators.
expansion
connector
Sensor Input:
pass wire
THROUGH HOLE
(do not strip
insulation)
pwr(–)
GAP
N/C
C
N/O
N/C
C
N/O
sect 'A'
sect 'B'
Mounting standoff,
use #6 wood
screw. 3/unit
+
12VDC
–
a c t i v a t i o n s e c t i o n
track
power
a dozen or so
Trak-DT type
detectors can
be operated
from one
12VPS
regulator.
track
power
For automatic stop's,
remove jumper, adjust
time accordingly.
(AC operators need to
lock engine in FWD).
Mode selector:
Jumper ON = mode 1, DTA
Jumper Off = mode 2, DTT
Station Stop Wiring
(single engines / trollies only)