Specifications

Halogen Lamp type F.R.E.D, STROBE, MARS, BEACON
Description size item#
Beacon .............. 5/8" ............ 1540
Beacon .............. 2" ............... 1541
STROBE ........... 5/8" ............ 1543
STROBE ........... 2" ............... 1544
MARS ................ 5/8" ............ 1546
MARS ................ 2" ............... 1547
F.R.E.D. ............. 5/8" ............ 1550
F.R.E.D. ............. 2" ............... 1551
All units produce white light, proper colored
lenses are required for different light
production.
Replacement high intensity 5/8" halogen lamp:
Item #1548
Replacement high intensity 2" halogen lamps:
Item #1549
All lamps are a narrow beam for the best concentrated
light and effect.
These units are designed to operate with a 12 volt, high
capacity, battery or fixed supply of 12 volts. They require
at least 20 watts. The lamp is supplied with a proper
socket to the base. Mounting the lamp properly is
required.
These units are primarily for 1" and larger operators.
They can also be used in a stationary environment.
MR-8 lamp
MR-16 lamp
28
The TURNTABLE INDEXER is designed to stop the
motor driving any turntable at many locations set by you.
This unit consists of a main circuit board that requires
the use of a fixed AC voltage to power it and a variable
source to operate the turntable motor. The TURNTABLE
INDEXER consists of a relay to switch the power to your
motor on and off as neccessary, and INFRA-RED
OPTICS to be used for alignment purposes. Space is
needed to mount the optics and a rotating disc below the
turntable is neccessary for angle brackets that are
needed for alignment to the optics. Installation and
alignment is quite simple. You merely fabricate angle
brackets out of thin shim stock or paper clips, mount
them at appropriate positions for bed alignment to the
optics, and then secure them with a screw. If at any
point a stall becomes misaligned, you merely loosen the
angle bracket and resecure at the corrected position.
You can also use the pre-printed laser patterns supplied.
These need to be mounted to any angle bracket or small
blocks of wood (not included).
Once the unit is installed and aligned you merely press
the pushbutton (included) to start moving to the next
stop position. If you do not want to stop at the next
position, merely press the pushbutton during transition
past the undesired stop position. A pushbutton is
supplied since it is easier to align with, you can
substitute a single pole single throw toggle switch
instead.
This turntable indexer was designed specifically for the
BOWSER turntable and motorizing kit but can be
adapted for use with practically any turntable.
Item # 617
Turntable Indexer
rotating lower disc with multiple stops -
may be set for any degree increment!
shown aligned to stop position.
optical sensor
Main Board