User's Manual

20
WARNING
3 Attach the warning labels
3.1 Attach the entrapment warning label on the wall near the door control with tacks or staples.
3.2 Attach the manual release/safety reverse test label in a visible location on the inside of the garage door.
Install The Photo Eye Safety System
Introduction
Be sure power is NOT connected to the garage door opener BEFORE installing the safety reversing sensor.
To prevent SERIOUS INJURY or DEATH from a closing garage door:
· Correctly connect and align the safety reversing sensor. This required safety device MUST NOT be
disabled.
I ll h f i b i NO HIGHER h 6" (15 ) b fl
To insert or remove the wires from
the terminal, push in the tab with a
screwdriver tip.