User's Manual

29
WALL Control
Using The Wall Control
Remote Control
PROGRAM A REMOTE USING THE CODE BUTTON
To Erase the Memory
ERASE ALL REMOTE CONTROLS
1 Press the CODE Button until the screen
shows “”.
2 Within 10 seconds,press the button on the remote
control , the “”will turn off. Press the button again, the
will flash and turn off. Now, congratulation!
Press and hold the CODE button on garage door opener, the “” will
turn on. Release the CODE button when the “turns off. All remote
control are now erased. Re
p
ro
g
ram an
y
accessor
y
y
ou wish to use.
Push Ba
r
Light button
Lock
PUSH BA
R
Press the
p
ush
b
ar to o
p
en or close the doo
r
.
LIGHT BUTTON
Press the Light button to turn the garage door opener lights on
or off. When the lights are turned on they will stay on until the
Light button is pressed again, or until the garage door
opener is activated. Once the garage door opener is activated the
lights will turn off after the 3 minutes. The Light button will not
control the lights when the door is in motion.
LOCK
The LOCK feature is designed to prevent activation of the
garage door opener from remote controls while still allowing
activation from the door control .This feature is
useful for added peace of mind when the home is empty .
Activate :press and hold the lock bottom until the LED is
flashing.The lock feature is activated and the your handheld
remote control will not operate your door at this time.
Deactiveate: press and hold the lock bottom again ,the LED
will stop flashing and normal operation will resume.