User's Manual
26
WARNING
CAUTION
1.6 The garage door opener will automatically open the door again,then close the door .
2 Test the Safety Reversal System
3 ADVANCED SETTINGS
Option A The “OPEN” position force sensitivity
Wi
t
h
out a proper
l
y
i
nsta
ll
e
d
sa
f
ety reversa
l
system, persons
(
part
i
cu
l
ar
l
y sma
ll
c
hild
ren
)
cou
ld
b
e
SERIOUSLY
INJURED or KILLED by a closing garage door.
· Safety reversal system MUST be tested every month.
· After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact
with 1-1/2" high (3.8 cm) object (or 2x4 laid flat) on the floor.
2.1With the door fully open, place a 1-1/2 inch (3.8 cm)
board (or a 2x4 laid flat) on the floor, centered under the
garage door.
2.2 Press the remote control push button to close the door.
The door MUST reverse when it makes contact with the
board.
If the door stops and does not reverse on the obstruction, the travel needs to be adjusted (refer to Adjustment Step
3). Repeat the test. When the door reverses upon contact with the 1-1/2 inch board, remove the board and open/close
the door 3 or 4 times to test the adjustment. If the test continues to fail, call a trained door systems technician.
3.1A Press and hold the SETTING Button
until the screen show the number from
“1” to “3”.
3.2 Press and release the DOWN Button
and the screen show the “ ∪”.
3.3A Press and release the SETTING Button and
the screen show the levels of the force
sensitivity.
3.4 Use the UP Bottom to increase the levels, press the
DOWN Bottom decrease the levels . The screen show
the number of the levels.
3.5A Press and release the SETTING Button and
the screen is flashing “||”. Adjustments is
Additional operator functions can be set using the advanced operator
fuctions.Parameters factory default settings can be restored .This programming
ma
y
onl
y
be carried out b
y
a
p
rofessional installer.