User's Manual

24
WARNING
CAUTION
Adjustments
NOTE: If anything interferes with the door’s upward travel it will stop. If anything interferes with the door’s downward travel, it
will reverse.
INTRODUCTION
Your garage door opener is designed with electronic controls to make setup and adjustments easy. The adjustments allow you to
program where the door will stop in the open (UP) and close (DOWN) position. The electronic controls sense the amount of
force required to open and close the door. The force is adjusted automatically when you program the travel and cannot be
changed.
PROGRAMMING BUTTONS
T he programming buttons are located on the left side panel of the garage door opener and are used to program the travel.
Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY
INJURED or KILLED by a closing garage door.
· Incorrect adjustment of garage door travel limits will interfere with proper operation of safety reversal system.
· After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact
with 1-1/2"
(
3.8 cm
)
hi
g
h
T
o prevent
d
amage to ve
hi
c
l
es,
b
e sure
f
u
ll
y open
d
oor prov
id
es a
d
equate c
l
earance.
PROGRAMMING
BUTTONS
SETTING
BUTTOM
CODE
BUTTOM
+ (UP BUTTOM)
_
(DOWN BUTTOM)