Specifications

UK DE DK JPN

5) “Crossover” adjustment: adjust the overlap between the subwoofer and the main speakers

by adjusting “Crossover” up and down until you hear the bass is smooth and without

“holes”. You may need to readjust the Volume setting (4) slightly after this adjustment.

6) “Phase” switch, 0° or 180°: adjust subwoofer phase to match the main speakers in the

speaker setup – try both settings to determine which setting sounds best. It might be

necessary to readjust both Volume level (4) and Crossover (5) again.

7) Mains cable connector: check that the voltage written below the mains connect matches

your mains voltage.

8) Fuse compartment: If the subwoofer does not power up, check that the fuse in the

fuse compartment is not blown. If blown, replace the fuse with the same type as

the original. If the fuse blows multiple times, have your subwoofer serviced at an

authorized service facility.

9) “Power” switch: powers the subwoofer on or off. Power off the subwoofer if it is not used for

extended periods. Always power off the subwoofer when changing connection(s).

10) Heat sink: do not cover! Caution - can be hot!

To connect the subwoofer to your stereo or surround sound system, please consult the owner’s

manual for your stereo/surround sound ampliﬁer to locate a subwoofer output terminal or a

pre-out output terminal. The subwoofer must be connected to the ampliﬁer using a RCA cable

(sold separately).

There are two primary connection options:

A) Connect the subwoofer to a stereo ampliﬁer

• Connect the output terminal(s) of the stereo ampliﬁer to the “Line Input L + R” connectors

on the subwoofer ampliﬁer.

B) Connect the subwoofer to a surround sound ampliﬁer

• Connect the subwoofer/LFE output terminal on the surround sound ampliﬁer to “LFE Input”

terminal on the subwoofer ampliﬁer.

12.0 TECHNICAL SPECIFICATIONS

In Table 2 (see page 24) you will ﬁnd most common speciﬁcations for our speakers. Please do

remember, that the sound quality from a speaker cannot be judged by technical speciﬁcations. To

compare the different speakers, we recommend you to listen to the different speakers in question.