Operation Manual

9
UK DE DK
4.0 CONNECTION
Before connecting or disconnecting any cables, always turn off the amplifier to avoid electrical
shock or damage to your equipment.
Channel the speaker cable through the groove in the Click ’n’ Connect wall bracket. Ensure the
positive terminal on the bracket (marked ‘+’ and coloured red) is connected to the positive output
terminal of the amplifier and negative (marked ‘–’ and coloured black) to negative (see figure 5).
Incorrect connection will result in poor stereo imaging and loss of low-frequency output. Always
make sure the terminals are tightened. Always use cables of the same type and length for the left
and right channels. We recommend using special speaker cables from DALI, available from your
local dealer.
NOTE: If you are using FAZON LCR in a surround system, follow the instructions included with
your surround amplifier, as even a single loudspeaker connected out-of-phase will make the bass
weaker and the soundstage unfocused.
NOTE: Make sure that the bare conductors are tightly gripped by the terminals with no loose wires
that could cause a short circuit and damage the amplifier.
5.0 MOUNTING
DALI FAZON LCR can be mounted either horizontally or vertically, using the supplied Click ’n’
Connect wall bracket.
NOTE: Please refer to the enclosed mounting template for correct orientation of the Click ’n’
Connect wall bracket, both for horizontal (see figure 6) and vertical mounting (see figure 7).
WARNING: Do NOT mount DALI FAZON LCR on the ceiling. The supplied Click ’n’ Connect
wall bracket is not intended for ceiling mounting.
5.1 TEMPLATE
Using the enclosed mounting template, carefully mark the four screw positions on the mounting
surface. To ensure an aesthetically pleasing result, we recommend that you use a spirit level to
ensure that the Click ’n’ Connect bracket is mounted absolutely level.
After the speaker cables have been properly attached, apply the four screws in the pre-drilled
holes and tighten them - using raw plugs if necessary.
Carefully slide the speaker onto the Click ’n’ Connect wall-mount, until you hear an engaging
click from the spring-loaded button (see figures 8 + 9). This automatically establishes the correct
electrical connection between the speaker and the amplifier.
To disconnect DALI FAZON LCR, simply press the spring-loaded button on the Click ’n’ Connect
bracket (see figure 10), and pull the speaker gently from the wall.
WARNING: Do NOT apply force if the DALI FAZON LCR does not slide easily onto the Click
’n’ Connect wall bracket. Instead, please check and realign the orientation of the moulded
grooves between the bracket and the speaker socket.