Technical data

3.
System description
TRIOS DALI is a room lighting controller. It can be used
for the following functions:
• Daylight-controlled light regulation
• Movement-controlled switching
• Manual dimming via switches or IR remote control
These functions can be set by means of the IRT 1090
remote programming control, used in conjunction with an
appropriate sensor. Up to 5 independent light groups can
be programmed.
The TRIOS DALI controller is accommodated in a
surface-mounted housing to which up to 20 electronic
DALI ballasts can be connected via the DALI line.
The system power of the individual DALI ballasts and
groups of ballasts can be disregarded.
Figure 5
Switch and sensor lines
Switches are to be connected using conventional
installation material for extra-low voltages
(e.g. U 72 1x4x0.5). Pre-connectorised cable material is
available for sensors and is described in detail below.
If longer cables need to be installed or tubes are used, a
cable of type U 72 1x4x0.5 can be employed. If long cable
runs are needed it is advisable to use shielded cable.
back to contents
3.1.
DALI system
3.2.