Technical data

8.
Figure 24 shows the recommended position for a light
sensor in a room with a window at the side.
Figure 24: Sensor position in a room with window located at
the side
To prevent direct light falling on the sensor, the
installation aids moulded on the sensor components
should be aligned as shown in Figure 25.
Figure 25: Alignment of the installation aids moulded on the
sensor components.
There may never be sufficient daylight in the shadow of
large cupboards or machinery. Such zones must not be
used as reflecting work planes for installation and setting
of light sensors.
Figure 26: No daylight regulation over areas in shadow.
back to contents