Technical data

7.
7.2.2.
Selector switch assignment
Switch 'ON' Left switch Right switch
123 4 5 67 8
•••
Channel 1 off / down Channel 1 on / up
••••
Channel 2 off / down Channel 2 on / up
••• •
Channel 3 off / down Channel 3 on / up
•••••
Channel 4 off / down Channel 4 on / up
••• •
Channel 5 off / down Channel 5 on / up
••••••••
Mode 5 Mode 5
Addressing with IRT 8050
The IRT 8050 can send many different commands, but as
it has only two buttons, the internal dip switches must be
changed.
The five steps:
1 Press Mode 5 button
- Open remote control device
- All selector switches to ON
- Close remote control device
- Press button
All lamps go to 100%
Red LED on TRIOS flashes
Lamps dim in succession to 3%
One lamp goes off
2 Channel selection
- Open remote control device
- Selector switch to position Channel 1 to 5
- Close remote control device
- Press button
Acknowledgement: Lamp lights up and dims.
The next lamp goes to 100%
3 Repeat step 2
until all lamps have been addressed
4 Wait 10 seconds
5 Select group
All lamps light up and dim
back to contents
Figure 13
Figure 14