Technical data

7.2.1.
7.2.
7.
Page 48/49
Allocating addresses and assigning
them to a luminaire group
Addressing can be carried out after installation has been
completed.This requires an IR receiver (IRR 8125, IRR
8124) and the IRT 1090 programming remote control or
the IR wall switch IRT 8050.When programming is
carried out, the luminaire or luminaire group gives a
confirmation by lighting up and then dimming.
Addressing with IRT 1090
The five steps
1 Press Mode 5 button
All lamps light up to 100%
Red LED on TRIOS flashes
Lamps dim one after another to 3%
One lamp lights up and dims
2 Channel selection
Acknowledgement: lamp dims, next lamp lights up and
dims up/down
3 Step 2 is repeated
until all lamps have been addressed
4 Wait 10 seconds
5 Select group
All lamps light up and dim
It is important to ensure
that the distance between
the IR receiver and the
IRT 1090 programming
remote control does not
exceed 2m.
Signal transmission
between the IRT 1090 and
TRIOS can be tested by
pressing the "P1" and "Off"
buttons in succession.
If the TRIOS does not
respond, the cause may be
one of the following:
Figure 12
back to contents
Distance between TRIOS and IRT 1090 too great Decrease distance and target more precisely
The group address of the IRT 1090 has been changed Press buttons "C" and "D" simultaneously for more
than two seconds.The left-hand red LED flashes
Press button "B" as often as necessary until the three
red LEDs at the top right light simultaeneously.
Press buttons "C" and "D" again simultaneously for
more than two seconds
Group
address
Channel
address
Mode