Users Manual

Thermal imaging riflescope RS2

Quick guide

Resolution

RS225-384：384*288

RS225-240：240*180

Profile

Menu button instruction

Power

 Long press for 3 seconds to turn on/off the thermal imager；

 Short press after power on to turn off the eyepiece, short press

Lens

(lens cap)

Focusing ring

TYPE-C

Monitor

WIFI

power, camera, zoom, color

PAGE 1
Thermal imaging riflescope RS2 Quick guide Resolution RS225-384：384*288 RS225-240：240*180 Profile TYPE-C Monitor WIFI Lens (lens cap) power, camera, zoom, color Focusing ring Menu button instruction Power  Long press for 3 seconds to turn on/off the thermal imager；  Short press after power on to turn off the eyepiece, short press
PAGE 2
again to wake up the eyepiece. Camera  Short press for camera, long press to start recording, short press again to end recording. Zoom  Short press for single zoom, long press for continuous zoom, 1~4 times cycle. Color code  Short press to switch the color code, long press to enter the user menu. Lens focusing  After the image is displayed, adjust the lens focusing to a clear state .
PAGE 3
before use if necessary, and place it at room temperature during USB charging.  Do not open the cover or modify it without authorization. Maintenance can only be done by authorized personnel of our company. FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.