Operator`s manual

The Console’s Swimming Menus and Settings
The two left LCD screens will show the lane module input
status by lane. Figures 63-64 show feedback for the
for the first and third buttons in Lane 3. Figure 65
shows a sample feedback from activating the
touchpad in Lane 3. All devices should be tested
before every session.
Scoreboard Test
These menus check the numeric scoreboard drivers.
Cycle ON/OFF
This menu checks the signal to the scoreboard.
Press [1] to toggle the scoreboard ON and OFF. When this menu is selected, an all ON signal
is sent at intervals of approximately 3 seconds. This will continue to cycle ON and OFF until
pressing [Enter] to continue.
Driver Address
This menu shows which addresses each of the drivers on
the scoreboard are set to. The address plugs were inserted
when the display was installed.
Press [2] to display the driver addresses. This will remain on the display until [Enter]
is pressed.
Digit Number
This menu displays the digit designation.
Press [3] to display a digit number. The number or letter will show which output on the
driver that digit is plugged into. This will remain on the display until [Enter] is pressed.
Figure 63: Button
One Feedback
Figure 64:
Button Three
Feedback
Figure 65:
Touchpad
Feedback
MENU-TEST
3- SCOREBOARDS
SB TEST MENU
1-CYCLE ON/OFF
DISPLAY ALL ON
ENTER TO EXIT
SB TEST MENU
2-DRIVER ADDRESS
SHOWING ADDRESS
ENTER TO EXIT
SB TEST MENU
3-DIGIT NUMBER
SHOWING DIGIT #
ENTER TO EXIT
From Main Menu – [5]>[3]>[1]
From Main Menu – [5]>[3]
From Main Menu – [5]>[3]>[2]
From Main Menu – [5]>[3]>[3]