Assembly Instructions

5 Shelf Steel Frame Kit
Assembly Instructions
211-8656 &
211-8658
Wall
Anchor
Kit
End
Stop
Allen
Wrench
Hex
Bolts
Connector
Anti-Skid
Pad
Shelf
Support
Shelf Back
Beam
End
Frame
BOTTOM
End Frame
TOP
Top
End
Top
End
Outer Side
(Smooth
Seam)
Outer Side
(Smooth
Seam)
Cross
Beam
Corner
Post
2 - End Frames TOP (9.5”x29.9”)
2 - End Frames BOTTOM (9.5”x29.8”)
10 - Shelf Supports (23.4”x.75”sq.)
1 - Shelf Back Beam (22.6”x.75”sq.)
20 - Triangular Shelving End Stops (1.25”x1.25”)
20 - Adhesive Shelving Anti-Skid Pads (.375”sq.)
4 - Connectors (2.75”x.63”sq.)4 - Connectors (2.75”x.63”sq.)
2 - Hex Bolts (M6x35mm)
20 - Hex Bolts (M6x30mm)
8 - Hex Bolts (M6x10mm)
1 - Allen Wrench
2 - Wall Anchor Kits
(2– Metal Strips, Screws and Anchors)
Parts Included:
Assemble unit on a carpet or flattened carton to
protect the unit and the floor from scratches.
NOTE: Shelf Units can be assembled without using Shelving End Stops by instead using
the Shelving Anti-Skid Pads
(see Step 7).
Step 1
Insert two Connectors
partially into the tops of
the Corner Posts of a
BOTTOM
End Frame
lining up the holes.
Secure with the Secure with the short
10mm Hex Bolts.
Step 2
Place a
TOP
End Frame
over the extended Connectors
in the
BOTTOM
End Frame.
Secure with the short 10mm
Hex Bolts.
Repeat Steps 1 & 2 with theRepeat Steps 1 & 2 with the
other set of End Frames.
Step 5
Attach the other End Frame
ASSEMBLY
to the open ends
of the assembled Shelf
Supports – using sets
of 30mm Hex Bolts
and and End Stops.
Always make sure
the bottom of the End
Stops align with the
bottom of the Cross
Beams.
Step 6
Attach the remaining Shelf
Supports to the assembled
End Frame Unit – using
sets of 30mm Hex Bolts
and End Stops.
Attach Attach Shelf Back
Beam (short support)
to the top holes on
the End Frames –
using only the 35mm
Hex Bolts.
Re-tighten all Hex Bolts
and be sure End Stops
align with bottom of
Cross Beams.
35mm
30mm
Step 7
Apply Anti-Skid Pads
to the four corners of
each level as shown.
Step 8
Complete Shelf Unit by placing DAKOTA
(24”x 7.75”)
Shelves on the various levels
(purchased separately)
.
Step 9 WALL ANCHOR ASSEMBLY (Optional)
Wall Anchor Kit
a. Position the
completed
Shelf Unit
against the
wall.
b. Wrap Anchor
Strips around the
rear of the 2nd
Shelf Support
from the top.
c. Mark the location
of the Anchor Strips,
drill 3/8” holes in
the wall and insert
the Anchors.
d. Screw the Wall
Anchor Strip to
the wall to secure
the Shelf Unit.