Assembly Instructions

3 Shelf Steel Frame Kit
Assembly Instructions
211-8661 &
211-8655
End
Stop
Allen
Wrench
Hex
Bolt
Anti-Skid
Pad
Shelf
Back
Beam
Shelf
Support
End Frame
Top
End
Inner Side
(Offset Seam)
Cross
Beam
Corner
Post
2 - End Frames (9.5”x 34.375”)
6 - Shelf Supports (35.4”x. 75”sq.)
1 - Shelf Back Beam (34.6”x .75”sq.)
12 - Triangular Shelving End Stops (1.25”x 1.25”)
12 - Adhesive Shelving Anti-Skid Pads (.375”sq.)
12 - Hex Bolts (M6x30mm)
2 - Hex Bolts (M6x35mm)2 - Hex Bolts (M6x35mm)
1 - Allen Wrench
Parts Included:
Assemble unit on a carpet or flattened carton to
protect the unit and the floor from scratches.
NOTE: Shelf Units can be assembled without using Shelving End Stops by instead using
the Shelving Anti-Skid Pads
(see Step 5).
Step 3
Attach the other End Frame
to the assembled Shelf
Supports – using sets
of 30mm Hex Bolts
and End Stops.
Always make sure the bottom
of the End Stops align with the
bottom of the Cross Beams.
Step 4
Attach the remaining Shelf Supports
to the assembled Shelf Unit –
using sets of 30mm Hex Bolts
and End Stops.
Attach Shelf
Back BeamBack Beam to
the top holes
on the End
Frames –
using only
the 35mm
Hex Bolts.
Re-tighten all the
Hex Bolts and be sure
the End Stops align
with the Cross Beams.
30mm
35mm
Step 5
Apply Anti-Skid Pads
to the four corners of
each level as shown.
Step 6
Complete Shelf Unit by placing DAKOTA
(36”x 7.75”)
Shelves
(purchased separately)
on the
various levels.