Tus neeg siv phau ntawv

User Manual DMAC-2USB
AU: CNR BY: SJE V3 REV: 11/08/22 Page 5 of 12
Software Installation Instructions
Important: Leave the Simple Sight hardware UNPLUGGED from the USB during installation. ONLY plug the
hardware into your computer AFTER the Simple Sight software has run for the first time. After this initial
installation you may plug and unplug at will with no issues.
Visit http://dakotamicro.com/software/Simple%20Sight/ and click on “Simple
Sight 1.0.10.exe.”
If prompted with a security warning, click “Run” to continue with installation. This
program is safe, but there is no Microsoft certificate. Continue to leave USB Device
unplugged!
Click “Save File” when asked if you would like to save this file.
Find saved files in your Downloads folder. Double click to open Simple Sight 1.0.10.
Setup Wizard will begin. Click “Next” to get started.
Select the destination folder to store this program. Then click “Install.”
When it is done installing, click “Finish.”
Once the software is successfully installed a Simple Sight software icon will appear on the
desktop. Double click this icon and run the program for the first time. Wait for about 10
seconds and let the program check for updates. If there are updates available, the
program will prompt you to install them; let the program update to the latest version.
During the update procedure the program will close and, upon completion, will prompt
you to re-open the program.
When the software first opens, you will see a screen similar to the image to the right that
should include the statement “Device Unavailable”. NOW you get to plug in your Simple
Sight! When the device is plugged in for the first time, Windows will identify the device
and assign the driver to it; please be patient as this will take a moment.
As soon as the device driver is installed and ready, the next screen will appear. This screen
means you are set up and ready to run. Now it is time to get your hardware all hooked up.
Cameras or wireless receivers will get their power through the SS hardware using the
included AC adapter. Simply plug in the cameras, receivers, or extension cables to the DM
camera ports and you should automatically, and almost immediately, see a picture.
Hover the mouse over the Menu icon in the lower left side of the screen and you will see
the word “Menu” pop up on the top of it; click the Menu screen to display the options.