Tus neeg siv phau ntawv

User Manual DMAC-2USB
AU: CNR BY: SJE V3 REV: 11/08/22 Page 10 of 12
Getting outside your home network:
This section will very briefly discuss what you will need to do to access your cameras from outside of the home
network. To clarity, as per the networking char displayed earlier in this document, we’re talking about
accessing the device located “inside” of your home network, and we will be accessing this device from
somewhere “outside” of your network, for instance a neighbor’s house, lake house, or hotel.
Using the “Tool” mentioned in the previous section, you will almost certainly know when you are able to
access the cameras from “outside” of the network. If the tool gives you the error message, “unable to
determine external network address,” something is not set up correctly withing your router, or it is possible
that your ISP may have blocked the Port you entered for Streaming.
If you still require assistance at this point, we must encourage you to contact someone who is familiar with
your router and help to configure it. Dakota Micro cannot assist you with this setting. There are literally
thousands of possible hardware options, and we can’t be familiar with them all, but most importantly the
router or firewall is your protection from hackers and viruses from the outside world and our technical
support staff is forbidden to make any changes to your firewall or any other device which may affect any
protection you may or may not have. Thank you for your understanding.
Warnings
1. When selecting a camera system from Dakota Micro, Inc., be sure to utilize the appropriate system for your
use. AgCam®, EnduraCam® and InnoPro® cameras are designed for high impact, moisture, vibration, and a
variety of other rough conditions. OverView® and RazerCam™ cameras and kit components are designed
for light use, low vibration, and low moisture. OverView® and RazerCam™ equipment is not warranted
when used in situations outside of the above-mentioned parameters. We always request that customers
keep in mind that our less expensive OverView® and RazerCam™ product line is cheaper because it does
not feature the reliability and durability of our AgCam® and EnduraCam® lines. The warranty available on
these products reflects that durability.
2. To avoid electrical shock and maintain optimal functionality, do not open the enclosures. High voltage may
be present and there are no user serviceable parts inside. All warranties will be void should any enclosures
be tampered with in any way.
3. Do not use any harsh chemical solvents, cleaning agents or corrosive detergent to clean away dirt on the
surface of the screen or lens.
4. On AgCam® and EnduraCam® products, the photo-chromic camera lenses have been made impact-
resistant and have been drop-ball tested according to Sec. 3.84,21 CRF BUT ARE NOT UNBREAKABLE.
Because they have been hardened chemically, they show no stress pattern. Inspect your lenses frequently.
Chipped or scratched surfaces will reduce protection. Such lenses should be replaced only by the
manufacturer.
5. Power to cameras is not interrupted by turning off monitor; 12v power source must be terminated when
not in use to avoid battery drain. To avoid this problem be sure when hard wiring a unit, use a fused circuit.
6. Do not use your Dakota Micro, Inc. camera system for anything other than legal surveillance and
observation uses. Dakota Micro, Inc. is not liable for any illegal or nefarious usage.