Caution : Please read this carefully before you proceed Basket Chair Label Picture Description QTY A Front Left Leg 1 B Front Right Leg 1 C Back Left Leg 1 D Back Right Leg 1 E Basket Seat 1 Page 1 OF 8
F Middle Left Side Panel 1 G Middle Right Side Panel 1 H Basket Top 1 I Cushion 1 Description QTY ① Bolt Plastic Cap 27 ② Nut Plastic Cap 15 ③ Bolt M6*15mm 13 ④ Bolt M6*35mm 15 ⑤ Nut 15 ⑥ Washer Ring 41 ⑦ Wrench 1 ⑧ Allen Key 1 Label Picture Page 2 OF 8
Before Beginning Assembly: Overview This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is provided to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Open the carton and place all the parts onto a clean, soft surface. Unpack all hardware packages. Place the Basket Seat(E) with its Mounting Positions, facing upwards . Attach Front Left Leg(A) to Basket Seat(E) with Allen Key(⑧, using Flat Washers (⑥) and Bolts (③) Repeat the same process with Front Right Leg(B)，Back Left Leg(C) and Back Right Leg(D) Do not fully tighten the Bolts. Step 2 Stand the Basket Seat(E) upright.
Step 3 Attach the Middle Right Side Panel(G) to the Basket Seat(E) with the Allen Key(⑧) and Wrench (⑦), using Bolts (④), Washers(⑥) and Nuts (⑤) . Do not fully tighten the bolts. Caution:Two or three adults are required for assembly at this step. Step 4 Attach the Middle Right Side Panel(G) to the Middle Left Side Panel(F) with the Allen Key(⑧) and Wrench (⑦), using Bolts (④), Washers(⑥) and Nuts (⑤) . Do not fully tighten the bolts.
Step 5 Attach the Basket Top(H) to the Middle Right Side Panel(G) and Middle Left Side Panel(F) with the Allen Key(⑧) and Wrench (⑦), using Bolts (④), Washers(⑥) and Nuts (⑤). Do not fully tighten the bolts. Caution:Two or three adults are required for assembly at this step. Step 6 Check for stability and then tighten all Bolts at all joints. Note: DO NOT fully tighten a Bolt in one go and then move on to the next.
Step 7 Cover all the Bolts with the Bolt Caps(①) and Bolt Caps(②) as picture 7.1 and 7.2 shows. Step 8 Place the Cushion(I) in the Basket. Your Basket Chair is ready for use.
Page 8 OF 8
