User Guide

Manual # 650400A

VHX-55J

Dakota Digital VHX Instrument Installation

For 1955-‘86 Jeep

Your new VHX-55J kit includes:

Control Box

(4x) 4-40 Lock Washers

(4x) 4-40 Thumb Nuts

(2x) Aluminum Brackets

CAT5 Cable

Universal Sender

Pack

Installation Manuals

VHX Display

PAGE 1
VHX-55J Dakota Digital VHX Instrument Installation For 1955-‘86 Jeep Your new VHX-55J kit includes: Control Box Installation Manuals Universal Sender Pack CAT5 Cable VHX Display (4x) 4-40 Lock Washers (4x) 4-40 Thumb Nuts (2x) Aluminum Brackets Manual # 650400A
PAGE 2
Installation 1. Remove the stock gauges from the dash. The only factory hardware to be re-used will be the four palnuts securing the main gauge to the dash. 2. Using the four palnuts kept from Step 1, secure the Dakota Digital main display to the back of the dash. 3. Slide the temperature gauge through the opening from the front. Using the provided lock washers, thumb nuts, and bracket, secure the gauge. Pay attention to the orientation of the gauge to keep the gauge at the proper reading level.
PAGE 3
4. Connect the quick disconnect ribbon cables to their respectively labeled counterpart. Note: (OIL-OIL) and (TEMP-TEMP). 5. Connect the CAT5 cable to the system. As the assembled cluster is installed into the dash, take care when routing this cable to the control box.
PAGE 4
6. Refer to the main manual to complete the rest of the VHX wiring installation. 4510 W. 61st St. N., Sioux Falls SD 57107 Phone: (605) 332-6513 Fax: (605) 339-4106 www.dakotadigital.com dakotasupport@dakotadigital.