Instruction Manual
2
SPECIFICATIONS
Machine
Specifications: 10 TON UTILITY BENCH 10 TON UTILITY FLOOR
Press Type Manual 10 ton Bench Manual 10 ton Floor
Cylinder Type Single Acting Single Acting
Max. Press Capacity 10 ton 10 ton
Ram Diameter 1 ½" 1 ½”
Ram Stroke 6” 6”
Head Travel Left / Right of center Left / Right of center
Travel Per Stroke 1/8” approx. 1/8” approx.
Width between uprights 16 ¾” 16 ¾”
Width between channels 3” 3”
Max. Ram to Table 16” 38”
Overall Height 36” 60”
Weight 132 lbs. 149 lbs.
1. INSTALLATION PLACEMENT:
CAUTION
INSTALLATION OF PRESS
PRESS PLACEMENT SELECTION
1. Location of press should be in a well lit area that will not interfere
with other machines or operations.
2. Carefully unbox machine components from shipping carton.
Inspect all packing as not to throw out any parts or manuals.
3.
When transporting the machine please use caution. If using a sling
have someone steady the machine while transporting it.
4. Install your press on a sturdy level floor surface, or work bench.
The machine must be anchored to the floor or workbench
securely.
5.
After installing the press, use the kerosene or degreasing product
to clean off the anti-
rust oil which was applied at the factory. Then
wipe machined surfaces (such as ram) with a light coating of
lubricant oil.