User manual

16 |

Gimbal

For safety reasons, please disconnect ESCs and Power Connection Adapter or remove

all propellers during configuration and system setup!

STEP1: Gimbal switch

If you use gimbal, please choose On here.

If you open the gimbal control in assistant software

during the configuration, please note that there is

output from F1 and F2 ports. Now you should not

connect these ports to ESCs which is wired with

propellers equipped motors.

If you want to use gimbal with an Octo-rotor, you have

to use S-Bus receiver, then you can use port T and R

for gimbal control. Otherwise, there will be no ports on

MC for gimbal.

STEP2: Servo travel limit

Range: -1000 to+1000

MAX/MIN are servo travel limits; adjust them to avoid

mechanical binding; Place your multi rotor on level ground,

adjust CENTER value of PITCH and ROLL direction to

make the camera mounting frame to your desired

angle-to-ground.

STEP3: Automatic control gain

Range: 0 to 100

Adjust the reaction angle of automatic control. The initial

value 100 is full angle. The bigger the gain the bigger the

reaction angle. Click [REV]/[NORM] button, and then you

can reverse the feedback control directions.

STEP4: Manual Control Speed

Range: 0 to 100

You should assign one of the knobs on your

transmitter to X3 channel for controlling the Pitch

direction (angle) of camera gimbal during flight first.

Adjust the reaction speed of pitch direction manual

control; the initial value 100 is full speed.

You should assign one of the knobs on your transmitter

to X3 channel for controlling the Pitch direction (angle)

of camera gimbal during flight. If parameter adjustment

was enabled on channel X3, the gimbal manual control

via channel X3 will not be force to disabled.

Step 1

Step 2

Step 3

Step 4