User manual

10 |
software. If not, switch any of two wire connetcions of
the incorrect motor.
3 Make sure the type of propeller matches the rotation
direction of motor.
4 You have to set your transmitter to ACROBATIC
Mode.
If you want to use gimbal with an Octo-rotor, you have
to use S-Bus receiver, then you can use port T and R
for gimbal control. Otherwise, there will be no ports on
MC for gimbal.
Customize
This segment is reserved only for very special case, such
as customized airframe in non-conventional rotor
arrangement. In the event, an airworthy multi-rotor craft
with such rotor arrangement will require customized
setting to meet WKM controller algorithm. Please write to
our support department or contact together with photos of
the multi-rotor for assistance.
Please refer to Customize Motor Mixer section in
Appendix for how to customize a central
symmetry multi rotor.