User manual

8 |
Connection
Antenna
Head
Ground End
· You should have a DJI Ground Station installed laptop
· Use the USB cable supplied by us to connect the ground end to
you laptop. One end of the USB cable has two heads, make sure
both of them are plugged into your laptop.
Air End
· 900MHz wireless data-link has two CAN ports. When you use it with Ace autopilot system and
low voltage servo, you should connect one CAN port to spare CAN port on autopilot system,
and connect another one to a battery whose output voltage is in the range of air end working
voltage.
· 2.4GHz wireless data-link has only one CAN port.
· Usually connecting one CAN port on air end to any spare CAN port on DJI autopilot system is
enough.
· WKM user should use it with PMU.
· High voltage servos & FBL systems can drain the flight battery fast. Please make sure your flight pack
is sufficient for the flight time intended.
· Make sure the antenna head of air end is erect down, then you can have the largest range.
Any spare CAN
port on DJI
autopilot system
Battery
Ace autopilot, low voltage servo and
900M data-link connection
Normal connection with
Ace, WKM autopilot system
Any spare CAN
port on DJI
autopilot system
Any spare CAN
port on DJI
autopilot system