User manual

31 |
Tips:
 While a mission is in process, you can still re-edit your mission by using EDIT. Please click EDIT in
mission editor to do so.Then the mission editor will return to the state as explained in previous
section Flight Mission Setting
 While a mission is in process, you can pause the mission by using PAUSE function. Please click
PAUSE, and the aircraft will slow down and stay hovering. Then click CONTINUE the aircraft will
resume the un-finished mission.
Mountain Mountain
When you set the waypoints for the aircraft to climb a mountain, please make sure that you leave enough
distance between the aircraft and the mountain to avoid collision caused by aircraft air speed.
Latitude
Altitude
Longitude
Please note that when you set a way point above water such as lake/sea/river, the default altitude the map
shows will be at the bottom of the body of the water. Please be careful in setting altitude over water.
4.2 Auto Takeoff and Landing
Please read this carefully in order for this feature to work properly. It is imperative that you understand the
procedures outlined before executing auto takeoff and landing functions. Users need to obtain Semi Auto
Takeoff and Landing permission. But WKM has this function built-in.
 Auto Takeoff
Only after all waypoints are assigned or edited, the mission is ready for taking off.
STEP1: Place transmitter throttle stick to the lowest position. Otherwise, a tip The aircraft is on the
ground, but the throttle is not in the lowest position, please do not switch to manual mode! will be
shown.
STEP2: Flip the flight mode switch to either GPS-Cruise or GPS-Atti mode.
STEP3: Press Go command on the keyboard, the aircraft main rotor will begin to spool up.
Notices:
Aircraft is ascending to waypoint altitude, please place throttle to mid-stick！ This warning will go away
after you place the throttle stick at mid-point, a safety feature in case you accidently bump the mode switch
from Auto to Manual.