User manual

22 |
3 Click Go
Click Go Mode is a real-time single waypoint flight mode. Under this mode, you can send a waypoint to your
aircraft immediately.
STEP1: Make sure your aircraft is already flying in GPS Atti. or GPS Cruise Mode.
STEP2: Click Tool Box Click Go Mode to open the window as the figure shows.
STEP3: Click Enter Click Go Mode. Now your aircraft will go into hovering station.
STEP4: Input the Altitude of the waypoint which you are going to set; Input the Speed at which your
aircraft is going to fly.
STEP5: Hold the Space key on your keyboard, move your mouse in the 3D map, left click to set the
waypoint. Then your aircraft will fly toward this waypoint immediately. You can also set a new
waypoint during the flight.
STEP6: Click Exit Click Go Mode, your aircraft will hover again.
STEP7: Click CONTINUE button to continue your previous flight.
Notices:
The aircraft will go into hovering station while the MC isn‟t receive a heartbeat package from the GS in 5
seconds; The aircraft will go into auto go home while the MC isn‟t receive a heartbeat package from the
GS in a minute.
Tips:
When in the Click Go Mode, all control sticks of the Tx are disabled. To regain control using the Tx, flip the
mode switch from Manual mode to Atti, GPS Atti, or GPS Cruise mode.