User manual

20 |
 Connection
Joystick  Choose Joystick
Refer to the user manual of the specific controller / Joystick you choose, and ensure the USB cable is properly
connected. Please
Notices:
ENSURE the Joystick is properly connected physically, do not disconnect the joystick connection when
Joystick Mode is activated.
 Calibration
Joystick  Calibration
Steps
Joystick (Type1)
Type1
Type2
Step 1
Place all trim levers (for
physical fine turning) in
their neutral, or centered
position. Click Next to
continue.
For Type 2 controller,
you might not have
these physical fine
turning levers. Click
Next to continue.
Step 2
Center all the sticks.
Click Next to continue.
Center you stick
including your throttle.
Click Next to continue.
Step 3
Move all of the sticks
through their complete
range of motion several
times. When completed,
click Finish.
Move the sticks through
its complete range of 3D
motion several times,
including pitch. When
completed, click Finish.
 Channel Mapping
JoystickChannel Mapping
 Each control channel can be reversed, and mapped to one of the control functions listed in
corresponding drop down boxes.(Fig①)
 These control function are „Roll‟, „Elevator‟, „Yaw‟ & „Collective Pitch‟, they represent the cyclic
and rudder control of your aircraft. For example, use helicopter to be aircraft model, shown in the
Fig.③