User manual

15 |
Fig①A WKM
1 View Mode
STEP1: Check Signal Strength: shows no communication between GS and MC, please check
Troubleshooting in Appendix. Otherwise communication is constructed, can go to next step.
STEP2: Find Aircraft: Shows LATI, LONGI and ALTI of aircraft, then the aircraft logo will be showed on
the map.
STEP3: Altitude Off Set: Click Altitude Off Set，you can just use the value recommended, and click OK.
Read the paragraph below to get more details.
STEP4: Find Home Point: Home point can be found only when GPS signal is good enough. If WKM,
Home Point is 20 meters above the aircraft position where user pushes the throttle stick first time; while
Ace is 30 meters.
STEP5: Switch Height or Elevation Mode: Height or Elevation Height mode shows relative height, and
the 0 meter is the aircraft height when you choose Height mode, above 0 is positive and below 0 is
negative. Elevation mode shows height above sea level.
STEP6: View Fly Trace, Instrument Board and State Information: For displaying flight track and aircraft
state. Contents are decided by autopilot system. Fig①A will be displayed if you are using WKM; Fig①B
will be displayed if you are using Ace.Instrument Board is showed in Fig②.
1.1 System Setting
Tips:
Fig②
Compass
Real-time
Vertical speed
Real-time
Altitude
Real-time
Ground speed
Real-time
Attitude
Fig①B Ace