User manual

13 |
 Target Line: Line between aircraft and current target.
 Data Link Setting:
 The waypoint number of one package.
 Upload one package.
 Retry one package timeout.
4. Language(语言): Click to change language, English or Chinese.
 中文.
 English.
5. Help:
 Check for Update: Update software here.
 About: Check your DJI Ground Station version here.
6. Enter location: Go to the location of your input.
7. Fly Trace: Click to show the trace of aircraft.
8. Path Etrude: Click if you want to see flight Path Extrude during mission editing.
9. Map Details: Click to see map details.
10. Instrument Board: Click if you want to display instrument board.
11. Editor: Click if you want to display mission editor.
12. Continue: If you switch into autopilot mode from waypoint mode, click Pause then click Continue,
the aircraft will continue the remaining (Unfinished) mission.
13. Pause:Mission pause.
14. Serial port selection.
15. Connect: Click to connect to main controller.
16. Find Aircraft: Click to find aircraft location.
17. Real-time coordinates of aircraft.
18. Find Home Point: Find your home location.
19. Real-time coordinates of home location.
20. One Key Takeoff: Click to take off the aircraft.
21. Set Home Point: Change your home point.
22. Go Home: Click to go home.
23. Height: Height mode.
Elevation: Elevation mode.
24. Altitude Off Set: Set up the altitude off set.
25. To show Real mode or Simulation mode.
26. Signal strength: Shows the connection state between controller and ground station
27. GPS: Real-time GPS signal quality.
28. ATTI: Real-time attitude quality.