User manual

7
Matters Need Attention
For safety reasons, please pay serious attention to all following items:
 Ensure nothing blocks the servo driver module rotation, to avoid motor damage.
 Camera’s HDMI resolution should be set to 1080i.
 Ensure to mount the side of servo driver module1 without ports to the aircraft nose
direction.
 The gimbal center of gravity has been set, whose position directly determine gimbal
performance. Please do not adjust the gimbal center of gravity by yourself.
 The gimbal is a high-precision control device. Do not remove any other screws in the
gimbal, which may result in bad performance or even damage.
 Do not unplug any cable attaching to the gimbal ports, or even change the mechanical
structure.
 Make sure all wiring is correct, otherwise may lead to gimbal abnormal work or even
out of control.
 Make sure to connect Video Transition Unit to gimbal controller before power on the
system.
 The standard gimbal video power cable is recommended.
 Make sure you solder the gimbal video power cable to the wireless video transition
unit correctly, to avoid the 12V power burn the gimbal or your own device. And
ensure the cables are insulated, to prevent from short circuit.
 Ensure the 12V power is safe for you own device when other power cable is used.
 Make sure the wireless video transition module current consumption does not exceed
1A, to prevent GCU from damage.
 Pay attention to that S800 power supply voltage is within the defined limits (6S), when
using one battery for both S800 and Gimbal power supply.
 Different camera or lens should use special component.